The application is possible with a masonry brush, brush, trowel, as well as a spraying aggregate. bonding layer on existing bituminous (asphalt) coatings.pre-sealing and adhesive layer for sealing of polymer-bituminous mastics (KMB).sealing wet and damp rooms (bathrooms, showers).sealing composite (sub-tile) balcony and terrace in.sealing water tank, including drinking water up to 15 m water column, as well as swimming pool, tank in sewage treatment plant.secondary insulation of buildings and structures (walls, floors), also bath type.sealing with negative water pressure (removing the waterproofing from the ground) - cavity up to 3 m below the groundwater table.foundation benches, foundation walls, foundation slabs) execution of horizontal and vertical waterproofing embedded in the ground of parts of buildings and structures (e.g.drying independent of atmospheric conditions (chemical bond).traffic load and the ability to cover tiles after 4 hours.tank filling in: after 3 days (at +23 C and 50% relative humidity) application (air and substrate) temperature from +3 C to +30 C.processing time ~ 45 min (at +23 C and 50% relative humidity).density of ready-mixed mortar ~ 1.05 kg / dm 3.setting and hardening - hydraulic and as a result of chemical reaction.the number of applied layers is a minimum of 2.the possibility of further processing after 90 min.based on cement, selected aggregate, special polymer in.It binds without scratches or internal stress. Translations of product names and their descriptions have been translated using Google Superflex D2 is a flexible, fast-setting sealing micro-mortar. Protect the fresh waterproofing layer against frost and rain for at least 4 hours. You should follow the rules of building art. Avoid strong wind and direct sunlight on the processed surface. Protect the freshly applied waterproofing layer from drying too quickly. Do not apply the material on the frozen substrate, do not work in negative temperatures or during rainfall. Temperature of the substrate and air during the performance of the work should be between + 3 ° C and + 30 ° C. Conditions during application and setting Prepare the amount of material that can be used during the processing. The prepared micro-mortar is ready for application. The mixing time is 2-3 minutes, then a 1-2 minute break is necessary and a short remixing is required. Add the powder component to the liquid component and mix with a low-speed mixer or a drill with a paddle mixer until a homogeneous, homogeneous mass is obtained. The liquid and powder components are supplied in the correct proportions. Waterproofing depends on the rod seizure of the sealed structure, moisture / water loads, presence of aggressive media, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |